Path Floor Mould is a paving mold used to make a cement (or red mud) garden path. It consists of irregular holes, which can fill the cement slurry in the mold, and then smooth the upper part by hand. When dry, take out the loading mold and sprinkle the stone sand (or plant the grass) in the gap.
Suitable for gardens, meadows, balconies, villas and more.
Easy to operate, ladies and children can also DIY their own garden.
It can be used repeatedly or multiple times at the same time until all the roads have been completed.
It is possible to make roads of different colors, and it is only necessary to blend the cement inside into colored, without expensive equipment and laying costs. Save money, convenience, beauty, and practicality.
Size: 33 x 33 x 3.6 cm
HOW TO USE:
Mix cement with water, according to package directions. When ready to use, the concrete will be the consistency of oatmeal and thick enough to hold an edge when you slice into it with a shovel.
Fill the paver mold, scooping the concrete in with a shovel and making sure to fill each area.
Using rubber gloves, spread the concrete around the mold, filling in any gaps or low points. Tap the mold with your hand to eliminate any air bubbles.
Following the contours of the mold, smooth out the concrete, wiping away any excess.
Allow the concrete to set for a maximum of five minutes, then carefully remove the mold. For the next stretch, rotate the mold a quarter-turn and place it beside the paver just completed, angling slightly if you're creating a curving pathway.
After letting the concrete cure overnight, fill the cracks with dirt and wash away any excess. Wet the ground around the newly formed pavers to help them settle